MonthAugust 2012

simple way to set time and date in bash

because I always forget:

date mmddhhMM

for examle:

sys:~# date
Sun Feb 19 06:01:32 CET 2012
sys:~# date 08271451
Mon Aug 27 14:51:00 CEST 2012
sys:~# date
Mon Aug 27 14:51:04 CEST 2012

reset HP iLO 3 Password

Someone in the office played me a trick, and configured an iLO configuration password. (Maybe it was me in a very weak moment, but of course I would never admit it.) Anyway, I was unable to configure the iLO and needed to reset it. Turns out, this is quite easy.
The following steps are necessary:

  • remove server from the rack and open the case.
  • locate system switches (Jumpers) (see Picture)
  • set the iLO security switch to ON (ON = security off, OFF = security on) (see red arrow on picture)
  • start the server and press F8 to enter iLO config menu
  • you will still be prompted for a password, but any will be accepted
  • set a new password, reboot and revert jumper settings

good luck!

 

find the switch to reset an HP iLO 3 password

find the switch to reset an HP iLO 3 password

© 2017 netmess

Theme by Anders NorenUp ↑